The Hoist Purchasing Mistakes That You Would Like To Avoid

On 7 Oct., 2019

Among all the considerations while buying a hoist, cost is certainly one of the biggest factors. But compromising on the quality to save a few bucks can come back to haunt you in the future!

The Hoist Purchasing Mistakes That You Would Like To Avoid

There are many lifting equipment suppliers in the market in various capacities like electric hoist of 500 kg, 1 ton, 2 ton, etc. Other than the proper selection of lifting slings, there are other aspects to it as well. To choose the perfect equipment, avoid these major mistakes to get the best equipment.

1. Buying a hoist that is not slow for the operation.

The lower the speed, the lower the horsepower, and the cheaper the hoist! This might look very enticing on the paper but it is important to look out for complaints from operators on the production line. They are the ones who operate on the field and have the best understanding of the hoist operations. A slower speed implies that it takes longer to do a job. Avoid this issue by checking the speed you require to complete the job at hand.

2. Not buying a powered trolley to save costs

There is a generalized rule to invest in a trolley. If the load can be pushed with ease, then a push trolley is fine. But often, the load is dangerous to handle, and it requires the operator to stand away from the load for safety. In these scenarios, it is clear that a motor-driven trolley is the best option to do the job.

3. Buying a manual hoist when a powered hoist is needed.

Manual hoists that lift and lower the load when the operator pulls the hand chain, are designed for relatively short heights. Any lift that has to cover more than 20 feet needs to be accomplished by a powered hoist. For example, a 1 ton electric chain hoist can make the 20-feet lift several times faster than the manual hoist, with little operational cost.

4. Purchasing a hoist with a finish that doesn’t blend with the environment.

Most manufacturers craft standard hoists that are finished with paints suitable for indoor use. However, if you need the hoisting equipment to be used outdoors or in an area where the environment can degrade it, a special finish is worth the extra pounds for the longevity of the equipment. In any case, it is always better not to purchase a hoist without any finish. Saving on the cost of painting might get the equipment rusted before it hits the factory floor.

5. Opting for the single reeved hoist when true vertical lift is required.

If you need the hoist to place an object precisely at a particular spot, then you need true vertical lift and a double reeved wire rope hoist. Single reeved wire rope hoists are perfect for any operation that does not mind “hook drift’ – or, when the wire rope cable moves laterally in the course of raising and lowering the load.

6. Purchasing a standard duty unit for a heavy-duty cycle.

There is a common mistake that everyone does. Suppose, you have a 5 ton operation, where the hoist is employed several times a day. It is a common notion that a 10 ton capacity hoist is able to do the job because it is capable of lifting twice the load. But, this is not the case! To allow for a high duty cycle, the hoist motor has to be upgraded, along with the hoist brake and the controls. Otherwise, a heavy-duty hoist is always a better option.

End Note:

After going through this article, let’s hope that you have grown a little wiser by learning about the mistakes that you should never make. Try to keep the above mentioned points in mind while buying a hoist, and you shall never regret later!