Such plastic parts, which are required to be absolutely dirt-free, are manufactured in a cleanroom environment in order to minimize the possibility of contamination.
If it is about the manufacturing of plastic parts, then no doubt that injection molding is one of the most preferred production methods and it is now being used widely by many manufacturers. It is because stable and long-lasting parts can be built through this method and that too at an affordable production cost, which is why it is believed to be the most suitable method for the manufacturing of plastic products. But have you ever heard about the Cleanroom Molding Small Batch or do you know why we use this method?
Continue reading this article to find out about the Cleanroom Molding Small Batch and the products built through this method.
It is no different from other injection molding methods, but the only difference is that the whole molding process is conducted in an absolutely clean room. In simple words, it can be said that such plastic parts which are required to be thoroughly dust-free are manufactured through the Cleanroom Molding Small Batch.
This process is basically used for the manufacturing of plastic products on a small scale, and the cost of production through this process is generally higher than the cost of production through normal injection molding methods. It is because a decent amount of money is needed to be spent, in order to maintain a clean environment in the room, which ultimately increases the manufacturing cost.
In brief, whenever you are required to produce flawless and dust-free plastic products, then the best alternative you have is clean-room injection molding. Below is some additional information about such plastic parts which are required to be manufactured through this process.
The medical, aerospace, pharmaceutical, military, and biotech are such industries where the plastic parts built in a dust-free atmosphere are needed very often. But the main thing you should keep in mind is that there are nine different classes of clean-rooms and therefore, depending on your requirement, you need to choose a relevant class for the production. You should also know that class 7 clean-rooms & class 8 clean-rooms are used the most all over the world, especially for the plastic parts used in the above-mentioned industries.
iMold USA LLC
ADD: 2220 Hillcrest Street Orlando, FL 32803